High beam indicator light IO
This indicator light comes on when the high beam of the headlight is switched on. 1. Dimmer switch ID D 2. Horn switch Osr 3. Turn signal switch lt c gt
Emission Hose Routing
CANISTER ROLLOVER TO ATMOSPHERE VALVE Cold tire normal pressure should be set as follows. FRONT 200kPa, 2.00kgf cm2 , 29psi REAR 225kPa, 2.25kgf cm2 , 33psi 90 kg 198 lbs maximum load FRONT 225kPa, 2.25kgf cm2 , 33psi REAR 250kPa, 2.50kgf cm2 , 36psi Cold tire normal pressure should be set as follows. FRONT 225 kPa, 2.25 kgf cm2 , 33 psi REAR 225 kPa, 2.25 kgf cm2 , 33 psi 90 kg 198 lbs maximum load FRONT 225 kPa, 2.25 kgf cm2 , 33 psi REAR 250 kPa, 2.50 kgf cm2 , 36 psi Left view Right view...
Left view XVS1100A
3. Shock absorber assembly spring preload adjusting ring page 3-17 4. Helmet holder page 3-13 5. Storage compartment page 3-14 6. Owner's tool kit page 6-1 8. Engine oil level check window page 6-10
Turn signal switch
To signal a right-hand turn, push this switch to gt . To signal a left-hand turn, push this switch to lt 3. When released, the switch returns to the center position. Since this model is equipped with a self-canceling system, the turn signal lights will self-cancel after the motorcycle has traveled both about 150 m 490 ft and for approximately 15 seconds. However, the turn signal lights can also be canceled manually by pushing the switch in after it has returned to the center position.
Main switchsteering lock
The main switch steering lock controls the ignition and lighting systems, and is used to lock the steering. The various positions are described below. All electrical systems are supplied with power, and the headlight, meter lighting, taillight and position lights come on, and the engine can be started. The key cannot be removed. All electrical systems are off. The key can be removed. The steering is locked, and all electrical systems are off. The key can be removed. 1. Turn the handlebars all...
Speedometer unit
The speedometer unit is equipped with a digital odometer and a tripmeter. The speedometer shows riding speed. The odometer shows the total distance traveled. The tripmeter shows the distance traveled since it was last set to zero. Pushing the TRIP button switches the display between the odometer mode ODO and the tripmeter mode TRIP. To reset the tripmeter, select it by pushing the TRIP button, and then push the TRIP button again and hold it down for at least one second. The tripmeter can be...
Loading
The total weight of the operator, passenger, accessories and cargo must not exceed the maximum load limit of 200 kg 441 lb . When loading within this weight limit, keep the following in mind 1. Cargo and accessory weight should be kept as low and close to the motorcycle as possible. Make sure to distribute the weight as evenly as possible on both sides of the motorcycle to minimize imbalance or instability. 2. Shifting weights can create a sudden imbalance. Make sure that accessories and cargo...
Location of important labels
Please read the following important labels carefully before operating this motorcycle. BEFORE YOU OPERATE THIS VEHICLE, READ THE OWNER'S MANUAL AND ALL LABELS. ALWAYS WEAR AN APPROVED MOTORCYCLE HELMET, eye protection, and protective clothing. This unit contains high pressure nitrogen gas. Read owner's manual for instructions. Do not incinerate, puncture or open.