Crankshaft Sensor Inspection
OThe crankshaft sensor has no power source, and when the engine stops, the crankshaft sensor generates no signals.
• Crank the engine and measure the peak voltage of the crankshaft sensor (see Electrical System chapter) in order to check the sensor.
• Check the wiring for continuity, using the following diagram.
B. Crankshaft Sensor
B. Crankshaft Sensor
Start the engine and switch the diagnosis mode to Dealer 1 mode to know all the problem that the DFI system has at the time of self-diagnosis. If the engine cannot be started, the self-diagnosis system does not detect dynamic condition of the camshaft position sensor. In this case, turn off the ignition switch and turn it on again to enter the Dealer 2 mode. In this mode, the system tells all the troubles which the DFI system had in both static and dynamic conditions.
Post a comment